1st Build Winree’s First Build

[CallumWinree]

Day 9:

Ran out of filament over night so I had to grab some spare at work today so basically wasted most of todays resources on that BUT I got some more of the chest done with the final lower piece going right now. Also trimmed some pieces on the m6c bringing it to its fully complete status! Just need to sand out some rough spots and paint it. I do plan to print some custom caps to cover the ugly trigger rod holding it together. I also took some of yalls advice and ordered 3 spools of Bambu petg so that’ll be here soon!

Lastly, I added some inserts from my old military helmet into the odst helmet to fit test and it’s beautiful. I’m so glad I printed at 100% scale rather than 95%. Tomorrow we will run the last spool dry!

 

[CallumWinree]

Day 10:

Going to try a new way to track everything so hopefully this list from memory is everything I need to do. I’ll review it tomorrow back on my computer lol

Helmet- printed

Mandible- not printed

Chest- printed

Lower chest- printed

Abdomen- printed

Side- printing currently

Back- not printed

Backpack- not printed

Shoulders- not printed

Biceps- not printed

Forearms- not printed

Belt- not printed

Thighs- not printed

Calves- not printed

Boots- not printed



M6c- printed

M7s- not printed

 

[CallumWinree]

Day 11:

I ran out of filmament, but my next order should be here any day now. I’m changing from PLA to PETG after hearing recommendations from a lot of different people about it. I’m not too worried about the heat resistance of it but if I can avoid and mitigate any risk, then I might as well since I won’t be losing any extra money on it really.

Helmet- printed

Mandible- not printed

Chest- printed

Lower chest- printed

Abdomen- printed

Sides- printed

Back- not printed

Backpack- not printed

Shoulders- not printed

Biceps- not printed

Forearms- not printed

Belt- printing now

Thighs- not printed

Calves- not printed

Boots- not printed



M6c- printed

M7s- not printed

 

[CallumWinree]

Day 12:

Nabbed my last roll of filament from work to hold me over until my PETG arrives tomorrow. Was able to get the codpiece and butt printed and started 1 grenade to hopefully just finish this roll off strong.

 

[CallumWinree]

Day 13:

Was able to get the butt, cod, 2/6 back pieces, some boot pieces, and a shoulder done yesterday and today! Amazing progress

Helmet- printed

Mandible- not printed

Chest- printed

Lower chest- printed

Abdomen- printed

Sides- printed

Back- printing

Backpack- not printed

Shoulders- printing

Biceps- not printed

Forearms- not printed

Belt- printing

Thighs- not printed

Calves- not printed

Boots- printing



M6c- printed

M7s- not printed