Zachturner009's Halo Reach Commando Foam Build

Status
Not open for further replies.
Made the back heels of my stompers, turned out okayish, mid section is next.
20200723_141939.jpg

20200723_142006.jpg

20200723_142008.jpg

20200723_142015.jpg

20200723_142020.jpg
 
Anyways, next is the biceps, it's going to be tricky, I normally scale on height but my biceps are 19.5 inches in diameter, so I don't know if the height of the bicep piece is going to take into account of the diameter of my bicep
 
I did it again, I swear I will get the scale down on the next one, built the bicep like 2 times now, the height was okay, but it couldnt get pass my forearm
 
After build a pair of biceps...three times, I got my scale down! Here is what I got.
20200826_152544.jpg

And that's it, it took a while to cut it all out, I'll dremel my bevel cuts and glue it all up tomorrow.
 
Anyway, only had time to throw together one bicep piece today, here it is, these were really difficult to scale, I couldnt scale height, or width because of the diameter my freaking biceps, so I just measured bas on depth, and had to add like 50ish mm to compensate for the pieces that stick out, anyway enough of the reading, look at it for yourself.
20200827_155103.jpg

20200827_155212.jpg

20200827_155216.jpg

20200827_155219.jpg
 
I'm going to build my shoulders attachments first, so I will start with the Commando one first and then my Security w/kukri
 
Status
Not open for further replies.
Back
Top