JeffZugale
New Member
Whoof, last couple weeks have been busy and tiring. I got into the shop last night but was just plain not feeling it. Instead of trying to do any serious work, I just measured out a bunch of the smaller pieces and did some sanding here and there.
I now have the magazine bottom, rear under side bits and the main rear sight block marked and ready to cut, drill and rout. I also started on the little piece that goes on top of the slide where the overbarrel meets it (not shown). I think I may try to prime the underbarrel over the holiday weekend to really see where it needs to be cleaned up and what the Filler Primer will take care of. There are a number of tight places that don't meet my Standard Of Perfectionism, but that the primer might just deal with.
Have a nice long weekend everyone...
I now have the magazine bottom, rear under side bits and the main rear sight block marked and ready to cut, drill and rout. I also started on the little piece that goes on top of the slide where the overbarrel meets it (not shown). I think I may try to prime the underbarrel over the holiday weekend to really see where it needs to be cleaned up and what the Filler Primer will take care of. There are a number of tight places that don't meet my Standard Of Perfectionism, but that the primer might just deal with.
Have a nice long weekend everyone...