Mirage Armor with Artaius Helmet (3D printed)

Carr

BMO
405th Regiment Officer
Ladies, gentlemen, and aliens; it’s time for another build thread. This here thread will be focused on my current project, which I’m getting ready to go full force into, and it’s a Mirage Armor Core, with the Rakshasa radio shoulder, and an Artaius helmet. The color scheme will be the 2024 Cloud 9 color pallet (not sponsored), which I chose because I thought it looked cool. The armor will be my very best attempt at a Tier 3 Deployment here and plan on showing it off at HCS 2025. So let’s get started.

First and foremost, I have the Helmet printed with all the little gizmos that attach to it. Along with that, the radio shoulder piece, both forearms, and shins are printed. They’re painted differently cause I had a different project in mind, but I need to repaint them.
b7fe14c9-eddb-4d97-bcdc-cb5d0846b30f.png
600a1120-4a3a-4d20-9390-a8eaacbb290c.png

This is the idea above:
IMG_2536.jpeg

The Helmet printed:

IMG_1941.jpeg

The Armor parts so far (ODST parts are for something else)
 
Love to see someone giving that coating some love! Don't have any particular team I support, but the C9 coatings have been some of my favorite.
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top