Since I don't have a lot of pictures I will just be telling you about the process of making the ODST armor. Since my dad and I have no experience making halo armor we watched the ODST armor tutorial's by AndreDFT which helped us a lot. We started with the chest plates. It took us about 2 or 3 days to make them. (I don't remember its been over a month since this was started.) Once we finished the chest plates we started the helmet which took about 8 hours. Once the helmet was made we went on to the shoulder pads we had to cut them down a bit since they didn't have good mobility. After the shoulders were made we went onto the gauntlets which are a bit tight so we might have to remake them. We decided to make a radio based off of one from Halo 3 and Halo 3 ODST. Once that was finished we moved onto the Butt, Hip and Crotch plates easy compared to the rest of the armor. After that we went onto the thigh plates Pretty easy with the skills we acquired while we made the costume. Finally we started to make the Shin Plates about a day before we glued the Knee Pads onto the Shin Plates we made a helmet attachment from halo reaches upgraded ODST helmet with the extra head protection. After everything was made we glued and sealed we started painting at the time of this edit. Since we are using rustoleom paint we have to wait two days before its ready to paint again. Time for pepakura
Update: This thread is dead, but I did finish the armor I'm trying to get picks.
Update: This thread is dead, but I did finish the armor I'm trying to get picks.
Last edited: