Back in the Game

I believe that I have all my pieces printed. Will start on the final product soon as I will also start printing the under suit.
 

Attachments

  • IMG_20240731_212425252.jpg
    IMG_20240731_212425252.jpg
    4 MB · Views: 52
I believe that I have all my pieces printed. Will start on the final product soon as I will also start printing the under suit.
as others have said those are some clean parts, this armor is looking amazing. if you ever want the parts to have a real smooth surface XTC 3D that stuff has almost no smell and a thin coat will give it a smooth surface if have used it before. and i have the same problem with the glass moving so i use blue painters tape to coat the bed and over lap it to go under the bed it does help.. but when you change tape you will have to re level the bed as you already know..
 
This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top