- Hall of Honor - Post Pics of your finished armor/weapons

Finished up this 1 to 1 scale MA37 a few months back, you might've seen it on r/Halo. 3D printed on a Creality CR-10 then spray painted and weathered with mostly Tamiya paints. Decals were designed by myself and printed onto water slide decal paper. It's my pinned tweet (@Vantave) and there's a bit more info there!
 

Attachments

  • ar1.jpg
    ar1.jpg
    442.1 KB · Views: 263
  • ar2crop.jpg
    ar2crop.jpg
    394.1 KB · Views: 265
  • ar3.jpg
    ar3.jpg
    395.8 KB · Views: 253
  • primed.jpg
    primed.jpg
    17.6 KB · Views: 252
  • sanding.jpg
    sanding.jpg
    12 KB · Views: 245
  • tape.jpg
    tape.jpg
    15.4 KB · Views: 262
Sean Bradley ODST kit I assembled and painted. Still looking at doing some upgrades and mods to the build. Added a shotgun shell strap to the chest a few weeks ago, and I'm gonna start printing the m6c socom here this week. I'm going to snag a nerf MA40 for the actual "primary" weapon of the build. Also, I've been eyeballing a Branfuhr Recon helmet to add to the loadout as well! I came from TDH and Star Wars builds, so I went the mindnumbing route of hand painting every single scratch and scrape on the WHOLE kit.
20191210_185149.jpg
received_2461385573984655.jpeg


received_460678151253822.jpeg
received_480927342621742.jpeg

received_1129806010723593.jpeg
20191212_223135.jpg
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top