Sup Nerds ,
So, I wasn't originally going to post anything about my project, but now that I've started.. I figured, what the heck.
Ever since the CQB was introduced in Halo 3, I've been crazy about it, and used it well into Reach. Although, I have to admit I did start to drift towards the JFO variant in Reach, but the CQB has always remained my first love. I've even started designing a new CQB variant... but that's a story for another time...
After some advice from Chernobyl, and some snooping around in the 3D thread, I decided to try my hand at cleaning up a model, and unfolding.
This is what I am hoping to accomplish:
(Ignore the Visor colour.. that's not happening )
- I would like to use a fan to blow air out of the vent above the visor, and use the top 'nuts' and the equipment mounts, as vents.
- For the inside, I'm going to use the lining and cheek pads from my old bike helmet since both lids are close in size.
- The visor will be removable, by a few mounting screws.
... and who knows what other knick knacks, and paddy whacks I can think of... but for now, that's mainly it.
Here's where I am currently at (Not sure why the first two rotated..) :
More to come!
So, I wasn't originally going to post anything about my project, but now that I've started.. I figured, what the heck.
Ever since the CQB was introduced in Halo 3, I've been crazy about it, and used it well into Reach. Although, I have to admit I did start to drift towards the JFO variant in Reach, but the CQB has always remained my first love. I've even started designing a new CQB variant... but that's a story for another time...
After some advice from Chernobyl, and some snooping around in the 3D thread, I decided to try my hand at cleaning up a model, and unfolding.
This is what I am hoping to accomplish:
(Ignore the Visor colour.. that's not happening )
- I would like to use a fan to blow air out of the vent above the visor, and use the top 'nuts' and the equipment mounts, as vents.
- For the inside, I'm going to use the lining and cheek pads from my old bike helmet since both lids are close in size.
- The visor will be removable, by a few mounting screws.
... and who knows what other knick knacks, and paddy whacks I can think of... but for now, that's mainly it.
Here's where I am currently at (Not sure why the first two rotated..) :
More to come!