Mech/Exoskeleton Build (Full-Size )

Hand is almost done: need some switches to control the motors and the screw drive housing.

IMG_20190804_180110410.jpgIMG_20190804_180117895.jpgIMG_20190804_180137086.jpg

Used some old holey socks as dust covers XD

Fixed up the other arm (kinda) and put the hand on. Fancy

IMG_20190804_190715241_HDR.jpg
IMG_20190804_190723048_HDR.jpgIMG_20190804_190733254_HDR.jpg

Need to adjust the hand mount: it's all jammed in between the frame and metal paneling giving Marduk a permanent thumbs up.
 
Bit of work with the hand:


Steering system works more or less as expected. Did a little fiddling to make the cockpit easier to get into: like making a floor!
Hopefully full test drive tomorrow will be installing:

-right waldo arm
-neck rotation power pack (removed when not in use)
-head camera mount
-head camera (removed when not in use)
-optical system core (removed when not in use)
-power cores (removed when not in use)

to do:
rear view camera (USB)
 


Write your reply...
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top