Pepa H3 AR *Project Complete pg. 7*

[Damien]

if you fiberglass the gun then the clip may not fit :eek

 

[Xavier]

what are you holding it together with??

 

[Sigma LS]

All I used was hot glue on the inside tabs to complete it. Clean, quick and painful.


I don't think the fiberglass will be too big of an issue as I can just sand the internal chamber to make it big enough to hold the slightly enlarged mag.

I think I'll still use PVC for the barrel though...

 

[Damien]

the texture looks like it is black tape

 

[UnDedSnipr]

Nice I'll have to try this some!

 

[Xavier]

dude... sooo awesome.. did u chop up the model or do u have one piece spanning several papers?

 

[Damien]

probably several papers

 

[Xavier]

ugh... ive never tried doing that... id imagine it being hard..

 

[Damien]

i tried the pistol, and didnt finish

 

[Sigma LS]

probably several papers

a few... :lindsey:

 

[blinkava44]

wow does that look confusing

im guessing it would look less terrifying without the texture

 

[Xavier]

jesus that looks impossible

what did u set the margin 2?

 

[Sigma LS]

The actual margin on the page is something like an inch but you can just cut the margin on one piece and overlay the corner crosshairs on the next over then glue it. BOOM instant perfectly aligned multipiece pepa!

I actually prefer the bigger complex pieces like this because for me it means the model will come out more symetrical and even though the cutting and scoring take longer, the assembly is a lot shorter.

 

[Xavier]

ahh

 

[Damien]

sounds like fun

 

[ragtagsoldier]

yea but there is the deal with edge id, nightmare

______________________

 

[Damien]

well that is a downside

 

[Sigma LS]

Update, back is done and front is half done. Bought materials for barrel and flashlight today.

 

[Silverzippo93]

I printed it out and the paper took up my whole floor! :eek

 

[blinkava44]

wow sigma, that looks awesome, cant wait for finished product!