Raw Build Start

[Exia]

I use “rust-oleum automotive primer 2in1 filler and sandable” with my prints and always finish with a coat of that then 400 grit sand then proceed to paint and clear coat! Makes for a very smooth piece!

Ah I was sanding a test with the broken extra part. I was sanding by hand and watching tutorials. I realize I think I was supposed to spray it with the 2 in one filler sandable first. Then sand it..... or I'm not putting enough power in my sanding lol.


I think I'm on the right track ish
I can see the lines not as much using that spray filler. And it's smooth. Perhaps doing this spray sand spray sand works out!