^ This...I hate you both............
^ This...I hate you both............
The struggle is realMrs. DD doesn't understand and wants nothing to do w/ Cosplay.........well then again, she doesn't understand 1/2 of the hobbies I've picked up over my long years.
Are you printing these 1:1 scale or sizing them down some?We have reached the point in the project where just looking at her puts a smile on my face. Hydra for scale.
View attachment 252684 View attachment 252685
All 1:1. I'm a bit of a lore nut so I want them to be to scale .Are you printing these 1:1 scale or sizing them down some?
Affirm, all of these parts are printed at 5% infill. Remember the weapon itself is 42 inches long (per the Halo encyclopedia). 5 lbs is nothing. But yes, there is a balance between wall width and infill percentage to ensure structural integrity.
My arm tried to fall off hah. Some lessons were learned. Once we get both of these fully figured out plan is to make ultra lightweight casts.Cause that Hydra was a brick! I don't now how your arm didn't fall off at Dragon lugging that thing around.
I am totally looking forward to seeing future Saws everywhere!!!!My arm tried to fall off hah. Some lessons were learned. Once we get both of these fully figured out plan is to make ultra lightweight casts.
My arm tried to fall off hah. Some lessons were learned. Once we get both of these fully figured out plan is to make ultra lightweight casts.