Waltimusprime
Active Member
Thought id show something i did that i thought was pretty cool and haven't really seen anyone do. Instead of the traditional reverse side of the foam on the upper vents of the back part of the reach torso i cut up soda cans and used to aluminum as the background. the picture doesn't do it justice because its a really cool addition and when the light hits it the reflection is a nice touch
Also another thing i did that i havnt seen anyone do is i cut apart the funnel hose off of a gas can and squeezed it into the middle spine part so that i could lace my EL wire through it i also did this on the 2 squared vent holes. i think it gives it a really nice touch aswell.
more airbrush work and a UNSC seal
Also another thing i did that i havnt seen anyone do is i cut apart the funnel hose off of a gas can and squeezed it into the middle spine part so that i could lace my EL wire through it i also did this on the 2 squared vent holes. i think it gives it a really nice touch aswell.
more airbrush work and a UNSC seal
